As Fat32/Fat Partition Format doesn’t support transfer of 4GB + data as a single data chunk so all u have to do is to change its partition format to NTFS .
It can be done through DOS Prompt.
It will also increase the writing speed of your pendrive by almost double..
Steps To Perform :-
Run CMD.EXE as an administrator,
Command What it does
LIST DISK Shows all mounted disks. Find your USB flash
drive in this list. You will need the disk #
for the next step.
SELECT DISK n Selects the disk that future commands will use.
Replace “n” with the disk # for your USB flash drive.
NOTE: Be careful that you don’t select your hard disk! The next command will wipe the selected drive clean.
CLEAN Erases all previous partition & volume information on the flash drive.
PRIMARY Partitions the flash drive as one partition for the whole drive.
SELECT PARTITION n Selects the new partition so future commands will operate on it.
ACTIVE Marks the new partition as active so the BIOS/UEFI can boot to it.
FS=NTFS QUICK Formats the partition with NTFS.
Do not format the USB flash drive with FAT32 because it will not work (more explanation below).
ASSIGN Assigns a drive letter to the flash drive.
EXIT Exits DISKPART
Now ur Done ! njoy